info_i_25x25.png See important information about Ubiquiti Devices and KRACK Vulnerability in this article. We will update this document as more information becomes available.

EdgeMAX - crear un puente de

Resumen


Para crear un puente entre dos interfaces:

  1. Crear un grupo de puente.
  2. Asignar interfaces al grupo puente.

Pasos


Utilice los siguientes comandos:

configure
set interfaces bridge br0
set interfaces ethernet eth1 bridge-group bridge br0
set interfaces ethernet eth2 bridge-group bridge br0
commit

Para mostrar la información del estado del puente, utilice los siguientes comandos:

ubnt@ubnt:~$ show interfaces bridge 
Codes: S - State, L - Link, u - Up, D - Down, A - Admin Down
Interface    IP Address                        S/L  Description                 
---------    ----------                        ---  -----------                 
br0          -                                 u/u                              
ubnt@ubnt:~$ show interfaces bridge detail 
br0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc noqueue state UNKNOWN 
   link/ether dc:9f:db:17:0d:5c brd ff:ff:ff:ff:ff:ff
   inet6 fe80::4ca0:8aff:fed7:5cf6/64 scope link 
      valid_lft forever preferred_lft forever
  
   RX:  bytes    packets     errors    dropped    overrun      mcast
           92          2          0          0          0          2
   TX:  bytes    packets     errors    dropped    carrier collisions
          414          5          0          0          0          0