Readers will learn how to verify the statistics of inserted SFP/SFP+ modules on an EdgeSwitch (ES) or EdgeSwitch X (ES-X).
NOTES & REQUIREMENTS:
Applicable to the v1.9.0+ firmware on all EdgeSwitch (ES) models and the latest firmware on all EdgeSwitch X (ES-X) models. Please see the Related Articles below for more information.
Devices and accessories used in this article:
Verifying the SFP/SFP+ Modules
The UFiber Multi-Mode fiber SFP module (UF-MM-1G) will be used to interconnect the EdgeSwitch and the EdgeSwitch X.
The Ubiquiti branded SFP/SFP+ modules and DAC cables are officially supported and compatible with all EdgeSwitch and EdgeSwitch X models:
1Gbps SFP modules
10Gbps SFP+ modules
10Gbps DAC cables
UDC-1DAC cable (1m)
UDC-2DAC cable (2m)
UDC-3DAC cable (3m)
Follow the steps below to verify the statistics of the inserted module on both devices:
GUI: Access the EdgeSwitch and EdgeSwitch X Web UI.
Navigate to the Dashboard tab and hover over the icon for the SFP port in the Port summary section.
NOTE: It is also possible to see this information by hovering over the ports in the (horizontal) port row.
The following information is displayed in this section:
Traffic Received / SentTotal Rx and Tx traffic seen on this port.
Frame errors / dropsTotal amount of dropped frames or frames with errors.
Inserted moduleSFP/SFP+ manufacturer and model number.
TemperatureReported temperature of the SFP/SFP+ module in Celsius (C).
RX / TX powerThe received and sent optical signal level in dBm.
Connected deviceInformation on neighboring device if available (MAC address, port ID and manufacturer).
If there is no information displayed in the Inserted module section, then it is possible that the used SFP/SFP+ module is not (fully) compatible with the device. Note that only the usage of Ubiquiti branded SFP/SFP+ modules and DAC cables is officially supported. If a module is detected but the link is down, try forcing the port speed and duplex values on both devices. See the SFP/SFP+ Interface Options article for more information.
On EdgeSwitch (ES) models, it is also possible to view this information using the CLI:
CLI: Access the EdgeSwitch Command Line Interface.
Enter the following commands from privileged mode:
show fiber-ports optics-info all
Link Link Nominal
Length Length Bit
50um 62.5um Rate
Port Vendor Name [m] [m] Serial Number Part Number [Mbps] Rev Compliance
-------- ---------------- --- ---- ---------------- ---------------- ----- ---- ----------------
0/9 UBNT 55 55 FT17010604075 UF-MM-1G 1300 1000SX
show fiber-ports optics all
Port Temp Voltage Current Power Power TX LOS
[C] [Volt] [mA] [dBm] [dBm] Fault
-------- ---- ------- ------- ------- ------- ----- ---
0/9 35.7 3.258 11.8 -5.981 -6.221 No No
The available statistics and information are:
Module serial number
Module part number
Link length (50um)
Link length (62.5um)
Nominal bit rate (Mbps)
Output Power (dBm)
Input Power (dBm)
Loss of signal (LOS)