info_i_25x25.png Due to unforeseen weather conditions we are experiencing higher chat wait times. Remember you can also submit a ticket and one of our support representatives will get back to you as soon as possible. We apologize for the inconvenience.

airFiber - How to Align an airFiber Antenna


Overview


Readers will learn how to properly align any airFiber antenna as well as important tips to take into consideration before the alignment process begins.

NOTES & REQUIREMENTS:
If this is your first time installing an airFiber radios, the entire process of alignment could take an hour or longer.

Table of Contents


  1. Introduction
  2. Before You Begin
  3. Steps: How to Align an airFiber Antenna
  4. Related Articles

Introduction


Back to Top

Our airFiber antennas have a purposefully narrow beamwidth, which is why antenna alignment is extremely important in order to get a successful link. Mis-alignment can cause serious performance issues or even loss of connectivity.


Before You Begin


Back to Top

  • Using a pair of installers in constant communication is essential, since during the fine-tuning stage, one installer makes azimuth and elevation adjustments on one airFiber radio while the other installer reports the received signal level at the other airFiber radio.
  • Fine-tuning is necessary because the main lobe of the receiver is more narrow than that of the transmitter, in both azimuth and elevation.
  • To accurately align the airFiber radios for best performance, you MUST align only one end of the link at a time.
  • For more convenient alignment, you may consider using long-range scopes (not included) temporarily attached to your airFiber radios. 
  • When testing the units in close proximity, use caution to not overload the receivers since the minimum link distance is 10m for airFiber5/5U/11FX/2X/3X/4X/5X, 25m for AF24 and 50m for AF24HD.
  • It's recommended that all users read the airFiber design guide.

Steps: How to Align an airFiber Antenna


Back to Top

  1. Mount master and slave radios with installers at both sides.
  2. Check the signal strength of unit #2 and then move the antenna of unit #1 a few degrees, using the AZ (Azimuth) and EL (Elevation) bolts.
  3. Check signal in unit #2 again.
  4. Repeat step 2-3 until you achieve the best possible signal.
  5. After you get the best signal strength in unit #2, repeat steps 2-4 for unit #1.
  6. Make sure there is a 1dB or less difference in signal between both chains.

 

Related Articles


Back to Top

airFiber - AF5 Link Deployment and Alignment Using DFS Bands

airFiber - How to Ground Your airFiber Properly