Overview
This article describes the different LED patterns found in the airFiber 5 (models AF5 and AF5U).
Table of Contents
Introduction
airFiber 5/5U incorporates two LED displays, one shows local Rx signal, and the other shows remote Rx signal strength.
Interfaces
|
Reset Button: To reset to factory defaults, press and hold the Reset button for more than five seconds while the unit is already powered on.
Remote Display: Displays the received signal strength in dBm of the remote airFiber radio.
Local Display: Displays the received signal strength in dBm of the local airFiber radio.
Management Port: 10/100 Mbps, secured port for configuration. By default, this is the only port that can monitor, configure, and/or update firmware.
Aux Port: Port for audio tone aiming.
Data Port: 10/100/1000 Mbps port handles all user traffic. |
 |
LEDs
|
LED Label |
State |
Status |
| GPS |
Off On Normal Flash |
No GPS Sync Operational (Stron signal) Non-Operational (Weak signal) |
| Master |
Off On |
Slave Mode Master Mode |
| Link Status |
Off Short Flash
Normal Long Flash On |
RF Off Syning (DFS countries only) * DFS CAC * RADAR Detected Beaconing Registering Operational |
| Remote |
On |
Displays the received signal strength in dBm of the remote airFiber radio |
| Local |
On |
Displays the received signal strength in dBm of the remote airFiber radio |
| Overload |
Fast Flash |
Overload Condition (Identify and eliminate any source of strong in‑band interference.) |
| (Unlabeled) | On | 10X (1024QAM) |
| 8x | On | 256QAM MIMO |
| 6x | On | 64QAM MIMO |
| 4X | On | 16QAM MIMO |
| 2X | Long Flash | QPSK MIMO |
| 1X | Normal Flash | 1x QPSK xRT™** |
| 0.25X | Short Flash | ¼x QPSK xRT** |
* Short Flash (1:3 on/off cycle) · Normal Flash (1:1 on/off cycle) · Long Flash (3:1 on/off cycle)
** Extreme Range Technology
Port LEDs
|
Port |
LED Label |
State |
Status |
| Management | Act |
Off On Random Flashing |
No Ethernet link Ethernet Link Established Ethernet activity |
| Speed |
Off On |
10Mbps 100Mbps |
|
| Data | Act |
Off On Random Flashing |
No Ethernet link Ethernet Link Established Ethernet activity |
| Speed |
Off On |
10/100Mbps 1000Mbps |