airFiber - What do the LED patterns on AF5 Mean?

airFiber 5/5U incorporates two LED displays, one shows local Rx signal, and the other shows remote Rx signal strength.

 

 
Interface Description
Reset Button To reset to factory defaults, press and hold the Reset button for more than five seconds while the unit is already powered on.
Remote Display Displays the received signal strength in dBm of the remote airFiber radio.
Local Display Displays the received signal strength in dBm of the local airFiber radio.
 Management Port  10/100 Mbps, secured port for configuration. By default, this is the only port that can monitor, configure, and/or update firmware. 
Aux Port  Port for audio tone aiming.
Data Port 10/100/1000 Mbps port handles all user traffic.  

LEDs

 

 

LED State

Status

GPS

Off

On
Normal Flash

No GPS Sync

Operational (Stron signal)

Non-Operational (Weak signal)

Master

Off

On

Slave Mode

Master Mode

Link Status

Off

Short Flash

 

 

Normal

Long Flash

On

RF Off

Syning (DFS countries only)

* DFS CAC

* RADAR Detected

Beaconing 

Registering

Operational

Remote

On

Displays the received signal

strength in dBm of the remote

airFiber radio

Local

On

Displays the received signal

strength in dBm of the remote

airFiber radio

Overload

Fast Flash

Overload Condition (Identify

and eliminate any source of

strong in‑band interference.)

(Unlabeled) On  10X (1024QAM) 
8x On 256QAM MIMO 
6x On  64QAM MIMO
4X  On  16QAM MIMO 
2X  Long Flash  QPSK MIMO
1X  Normal Flash  1x QPSK xRT™**
0.25X  Short Flash  ¼x QPSK xRT**

 

* Short Flash (1:3 on/off cycle)

Normal Flash (1:1 on/off cycle)

Long Flash (3:1 on/off cycle)


** xtreme Range Technology

 

Port LED

 

Port LED State Status
Management Act

Off

On

Random Flashing

No Ethernet link

Ethernet Link Established

Ethernet activity

  Speed

Off

On

10Mbps

100Mbps

Data Act

Off

On

Random Flashing

No Ethernet link

Ethernet Link Established

Ethernet activity

  Speed

Off

On

10/100Mbps 

1000Mbps

Powered by Zendesk