airFiber radios are super-high performance Point-to-Point systems, so one unit must be the Master and the other unit must be the Slave.
Note: When the radios are running in Half-Duplex mode, it's recommended to always set the same Wireless Mode in all the units located at a specific location.
airFiber radios can operate in Full-Duplex (FDD) or Half-Duplex (HDD) mode. Full-Duplex offers the highest performance and lower latency (below 1ms) but requires perfect Line of Sight and perfect alignment in most cases. On the other hand, Half-Duplex mode is more tolerant to misalignment and in certain cases can work in nLoS (near LoS) scenarios, especially in lower frequencies, like in 2.4GHz (AF-2X).
Here's a table showing different Wireless Duplex Modes for each model:
|Full-Duplex (FDD)||Half-Duplex (HDD)|